1.Identify the plan of pedestrian barrier gate. When communicating with customers, determine the plan, the width and length of the site, and make it clear that several machines can be installed, which is the choice of vertical pedestrian barrier gate or bridge pedestrian barrier gate. In determining the type selection, full consideration should be given to the clearance between the gate and the brake rod, the area occupied by each wing brake, the location of each wing brake, and the wiring (bright or dark).
2.Fixed position before wiring. According to the previously determined scheme, the specific size of
pedestrian barrier gate installation is specified. Embedded pipe, and there is 50-100mm gap between the gate and the gate. The top cover can be opened in case of adjusting the machine, maintenance, etc. A gap must be left. Two plastic pipes of 6-8 minutes are embedded between the brake and the brake. One rubber hose takes the power line (strong electricity) and the other one takes the signal line (weak electricity). It is impossible to take the power line and the signal line in one rubber hose at the same time. This will affect the effect of communication. Embedded pipes should be 30-40 mm high above the ground. Walking vertical pedestrian barrier gate should be at the bottom of the middle of the machine. Bridge pedestrian barrier gate should be at both sides (because the middle bottom of the Bridge Wing brake is closed).
3. Fixed adjustment. Fix the bottom with a screw. It can't swing. The whole plane is horizontal and has the same appearance as a whole. (Before fixing, it is better to draw straight lines with thin lines, both vertical and horizontal alignment). Series connection is adopted between the winglets and the winglets, and the straight lines can be adjusted one by one. The straight lines can be used normally.
English
Español